Posted on February 4, 2009 - by Richard

Another HHO Tips for Fuel Gas Savers!

These hho tips refer to the Utube video I saw the other day showing a hho gas generator installed on a truck or minivan. It showed the hho generator showing 3 hydrogen cells connected together. The question is why?

Some vehicle engines especially those with sizes ranging from 5.0L to 6.0L would need a bigger output of hho gas. With a typical stand alone generator, the number of plates used for electrolysis is pretty limited. So when it is operating, problems like generator overheating and insufficient hho gas flow can occur. To resolve this, here is are a few hho tips being done by some vendors:

Adding a hho gas cooler to the system

Using a condenser coil in front of your radiator where the hho gas is made to circulate the hho cell can lower the hho gas generator temperature. And from what I have seen from a hho vendor, he added a circulating pump to increase the flow rate. This helps resolve both issues of overheating and insufficient hho gas production.

With this feature, it can avoid installation multiple hho cell installation which requires a bigger space in your engine compartment. With this hho tip, there is a downside: the added cost of the condenser coil and circulating pump can easily jack up your over-all hho investment roughly by 30%-40%. However, if you look at a more stable hho production without worrying about overheating, this might be a good route to go.

Another hho tips success story:

Shown in this utube video is hho gas generator using 3 hydrogen cells. As per the person who made the video, he gained 34% mpg gas savings. Please treat this caution because it does not show exactly what electronic extensions were used like PWM, EFIE or MAP enhancer. Should you need any assistance on this, please contact ATS or leave a message in my comment below.

Please check with your local city by-laws before performing any hho conversion in your vehicle. Please check ATS recommended strategies in our previous blogs.